The purpose of this try was to incorporate several unalike techniques in measuring length as well as to acquire experience necessary for handling scientific selective information that we will come across through fall away the lab.
Procedure/ regularity:
In this experiment, we low started out by measuring four-spot diametrical measurements of the height and width of the rectangle on pg. 20 in cm. We besides measured the height in inches. Then, we utilized the vernier scale caliper to measure the dia cadence and length of a provided piston chamber three time. Lastly, we used the micrometer calipers to measure a provided block. We also preserve the zero reading of the micrometer three times prior to measuring the sides of the rectangular. Four readings of each side were taken, the largest, intermediate, and narrowest sides.
The order used to convert the measurement in inches to a denary was to take the recording of the issue plus the fraction out of 8 and add it to the nearest tenth of the smallest division. For the Vernier Caliper, we recorded the reading by finding a secernate on the sliding scale that lined up with any mark on the fixed scale. Then the lines that line up with the outcome on the fixed scale is recorded based on the intervals between two of the numbers.
For the micrometer, the number of millimeters on the frame is branch read. If the next mark is visible, we add 0.5 mm. Then we add the number on the cylinder times by 0.01 mm to the first reading
Conclustion/Discussion:
In conclusion, in this experiment, we learned different techniques in measuring length using a meter stick, Vernier Calipers, and the micrometer. We computed our results through equations given to us in experiment 1. Our results had some inconsistencies due to mistakes in relation to personal technique. As we measured our error and uncertainties, we figured that our data was not as accurate as we would like it to be, however, we were able to figure out why the data came out the...If you want to get a full essay, order it on our website: Ordercustompaper.com
If you want to get a full essay, wisit our page: write my paper
No comments:
Post a Comment